Krone Comprima F 155 XC, Оригинальная инструкция по эксплуатации, Страница: 245 / 278

Malfunction, cause and remedy 19
Faults of the electrics/electronics 19.5
Comprima F 155 XC
Original Operating Instructions 150001050_01_en 245
522022-
Net wrapping
Possible cause Remedy
FMI 7: The net is running, even though tying has not been started.
The net is pulled during bal-
ing. „ Check and adjust the wrapping material brake, refer to
page 176 .
„
Check whether the claws on the brake disc are functional
and whether, as a result, the cardboard tube of the net roll is
held properly in place.
The net overhang is too long.
„
Check the net overhang. Ensure that it does not exceed
250 mm. If required adjust,
refer to page 175 .
„
Adjust the brake force release during the feed process, refer
to page 177 .
522022-
Chamber film wrapping
Possible cause Remedy
FMI 7: The film is running, even though tying has not been started.
The film is pulled during bal-
ing. „
Check and adjust the wrapping material brake, refer to
page 176 .
„ Check whether the claws on the brake disc are functional
and whether, as a result, the cardboard tube of the film roll
is held properly in place.
The film overhang is too long. „ Check the film overhang. Ensure that it does not exceed
250 mm. If required adjust,
refer to page 175 .
„
Adjust the brake force release during the feed process, refer
to page 177 .
522023-
Feed roller net wrapping/chamber film wrapping
Possible cause Remedy
FMI 7: The speed of the feed roller is below the minimum when the net or film is pulled.
The machine is blocked.
„
Remove the blockage.
The PTO shaft is rotating too
slowly. „
Set a higher rotational speed via the tractor on the PTO
shaft.
The sensor B01 "Speed of
bale chamber" is defective or
has been incorrectly set. „ Check and set the sensor.