Krone Comprima F 155 XC, Оригинальная инструкция по эксплуатации, Страница: 261 / 278

Repairs, maintenance and settings by technicians 20
Servicing the brake system 20.1
Comprima F 155 XC
Original Operating Instructions 150001050_01_en 261
2
8
Y
3.1
3.2
3.1 3.2
Z
X
1
X
2
1
Y
2
1.1
1.2
9.2 9.1
W
5 7
10
4
6
8
RP000-433
Checking the brake
„ Actuate the brake.
ð
If the cylinder stroke is W=25±5 mm , the setting is correct.
ð
If the cylinder stroke W is greater than 30 mm, the brake linkage (3.1, 3.2) must be
extended.
„
Check whether the wheels turn freely when the brake is released.
ð
The unbraked wheels must be able to rotate freely without grinding noises.
ð
If the wheels do not rotate freely, the brake linkage (3.1, 3.2) must be shortened.
„
Before putting the brake back into operation, check that the safety installation functions.
Setting brake linkage
If the dimension W is not within the range W=25±5 mm , the brake linkage (3.1, 3.2) must be
extended as follows.
ü
The machine is shut down and safeguarded, refer to page 27 .
ü
The pad thickness of the brake shoes must have a minimum thickness, refer to page 258 .
ü The brake drums have been checked, refer to page 258 .
ü
For all settings the compensation lever (5) must be positioned both in the oblong hole (4) at
the rear and in the upper area (6) of the support / holder (7).
„ Loosen the respective counter nuts (2) or (8).
„
Turn the respective brake linkage (3.1) or (3.2) so that the respective brake linkage (3.1,
3.2) is extended.
„ Always ensure to change the length of both brake linkages (3.1, 3.2). The brake linkages
(3.1, 3.2) may have to be extended to a varying degree.