Krone Comprima F 155 XC, Оригинальная инструкция по эксплуатации, Страница: 93 / 278

Operation 8
Net and chamber film wrapping 8.16
Comprima F 155 XC
Original Operating Instructions 150001050_01_en 93
Pre-settings for net wrapping:
• The tension lever (12) must touch and guide the wrapping material roll (1). To do this, the
tension lever (12) must be released,
refer to page 179 .
• The conical roller (3) must be locked to prevent it from rotating during net wrapping, refer to
page 180 .
Pre-settings for chamber film wrapping:
• The tension lever (12) must not touch the wrapping material roll (1). To do this, the tension
lever (12) must be locked,
refer to page 179 .
• The conical roller (3) must be released to ensure that it rotates during chamber film
wrapping,
refer to page 180 .
ü The machine is shut down and safeguarded, refer to page 27 .
ü
The roll holder has been swivelled forwards.
ü
The conical roller (3) has been locked or released depending on the set net or chamber film
wrapping,
refer to page 180 .
ü
The tension lever (12) has been locked or released depending on the set net or chamber
film wrapping,
refer to page 179 .
ü
The wrapping material brake has been set to net or chamber film wrapping, refer to
page 176 .
„
Unwind a section of the wrapping material (11) from the wrapping material roll (1) and guide
it over the deflection roll (2) and under the deflection roll on the cross tube (10).
„ Place the wrapping material (11) over the conical roller (3).
„
Place the wrapping material (11) under the spreading roll (4) on the retaining sheet (6).
„ Using the supplied feed plate (7), push the wrapping material (11) between the retaining
sheet (6) and the synthetic cloth (5).
„
Ensure that the wrapping material (11) is spread over an area (8) of at least 2 feed strips.
„ Ensure that the wrapping material (11) projects over the edge of the retaining sheet (6)with
one of the following lengths:
• For net: X=170–200 mm
• For film: X=230–260 mm
To check the position of the feed rocker arm, refer to page 171 .
To set the number of net layers, refer to page 140 .
To set the number of film layers, refer to page 140 .
8.16.3 Notes on operation
• When chamber film wrapping starts, it is necessary to continue collecting crops until the film
is caught by the round bale and the film roll is turning.
• If possible, for initial operation, use a complete net roll first and tie the round bales with net.
This way provides for previous removal of any sharp edges or paint residues.
• KRONE recommends not to use chamber film wrapping for straw bales. There is a risk of
condensation forming, resulting in mould.
• Tie the round bale with the appropriate film tension, refer to page 94 .
• KRONE recommends 3.5-4 film layers to ensure optimum chamber film wrapping, refer to
page 140 . The dryer the crops, the more film layers will be required.
• KRONE recommends no fewer than 2.5 net layers for optional net wrapping, refer to
page 140 . Otherwise, depending on the quality of the net and crops, the expansion force of
the crops cannot be absorbed by the net.
• A machine with chamber film wrapping can still tie round bales with net. In doing so, ensure
that the the conical roller and the tension lever are set differently.
• Setting the locking of the conical roller: refer to page 180
• Locking/releasing tension lever: refer to page 179