Krone Big Pack 127 / MultiCut, Руководство по эксплуатации, Страница: 95 / 132

XII - 3
Special Equipment
BP-VFS-031
1
B
BP-VFS-032
A
The cutter system blades can be reached from
underneath the machine.
12.1.4 Changing blades
Clean the conveyor channel before
changing the blade.
Put the blade control shaft into an
intermediate position
An intermediate position is a setting
between 2 control settings.
Turn the locking lever (3) to the right (selector disc
unlocked).
Turn the blade control shaft (2) to an intermediate
position using the special spanner (1).
Unlocking the blade shaft
Pull out the retaining pin (1).
Swing the safety lever(2) to position "
B " until the
retaining pin (1) clicks in.
Position " A ": knife shaft locked
Position " B ": knife shaft unlocked
If the knife shaft should be difficult to turn use open-
ended wrench "24".
Changing blades
Lift knife (1) at the rear (
I
) and pull it to the top (
II
)
until it comes clear of its mounting. Then swing knife to
the bottom and to the front (
III
) and take it out ot the
rear (
IV
).
Install the new knife and secure the knife shaft again.
BP380-7-110
BP380-7-109