Krone Big Pack 127 / MultiCut, Руководство по эксплуатации, Страница: 89 / 132

X - 1
10. Over the Winter
10.1 Special Notes on Safety
• Repair, care, maintenance and cleaning work may only be carried out with the machine at a
standstill. Switch off the engine and remove the ignition key. Apply the flywheel brake.
• Secure the big pack baler and the tractor from rolling away.
• After completing care and maintenance work, replace all protective plates and protective
devices again properly.
• Avoid skin contact with oils, greases, cleaning agents and solvents.
• In case of injuries or burns caused by oils, cleaning agents or solvents, seek immediate
medical attention.
• Follow all other notes on safety to prevent injuries and accidents.
10.2 General
Before putting the big pack baler away for the winter, clean inside and outside thoroughly. If using a high-pressure
cleaner, do not direct the water jet at the bearings. Lubricate all lubrication points after cleaning.
Do not wipe away
any grease coming out of the bearings. The grease ring provides additional protection against moisture.
Remove drive chains and chains for the chain coupling ( then check rake setting ) and wash in petroleum (do not
use any other solvent). At the same time check for wear on the chains and chain wheels. Oil the chains once
cleaned and then mount and tighten up again.
Check that all moving parts such as deflection rollers, joints, tensioning rollers etc. can be moved easily. If
necessary dismount, clean, grease and remount. Replace with new parts if required. Only use genuine
KRONE
replacement parts.
Take the PTO shafts apart. Lubricate the inner tubes and the guard tubes. Grease the lubricating nipple on the
universal joint as well as the bearing rings on the guard tubes.
Park the big pack baler in a dry place away from artificial fertilisers and animal stalls.
Touch up the paintwork where required. Protect bare spots, especially the twine lugs, the knotter (knotter clamp
and the twine retaining disk) and the bale channel thoroughly with plant-based oils.
Only jack up the big pack baler with a suitable vehicle jack. Make sure that the machine is in a
stable position when jacked up.
Jack up the round baler to prevent damage to the tyres (damage to the tyres can occur when the round baler
stands in the same position for a long time). Protect the tyres from the effects of oil, direct sunshine etc.
Release the parking brake and the flywheel brake. Drain condensation from the compressed air reservoir tanks.
Have the necessary repair work carried out in the time directly after the harvest season. Prepare a list of all spare
parts required. By doing this it is easier for your KRONE dealer to process your orders and you can be sure that
your machine will be in top condition for the start of the next season.