Krone Big Pack 127 / MultiCut, Руководство по эксплуатации, Страница: 25 / 132

III - 3
Preparing the Big Pack Baler
3.3 Adapting the Main PTO Shaft
• Before sliding the PTO shaft on to that on the tractor, switch off the tractor PTO shaft,
switch off the engine and remove the ignition key. Apply the flywheel brake.
• Secure the big pack baler and the tractor from unintentional rolling away.
• Nobody may be between the tractor and the big pack baler when carrying out the cornering
required for the adaption of the PTO shaft length.
To adapt the length of the PTO shaft attach the big
pack baler to the tractor. The shortest PTO shaft
position is reached when going round tight corners.
To measure, take the PTO shaft apart and slide each
half (1) and (2) on to the baler and the tractor
respectively. The exact procedure for the length
adaption can be found in the PTO shaft manufacturer's
operating instructions.
2
1
BP380-7-171
On the machine side, remove first guard (1) and the
bolts (2). Then connect the PTO shaft and secure using
the bolt supplied. Re-install guard (1) making sure that it
is positioned inside the first fold of the PTO shaft
bellows. Use the chain to secure the bellows against
rotation.
Installation of the flywheel brake
Place the brake housing onto the drawbar and tighten
the securing bolts. Check that the brake disc runs freely
through the brake saddle. For any correction of the
brake adjustment see section 6.13 “Basic adjustment of
the flywheel brake”.
BP380-7-008
1
2