Krone Big Pack 127 / MultiCut, Руководство по эксплуатации, Страница: 59 / 132

VI - 5
Settings
The adjustment is made by undoing the screws (3) and
(4) on the twine bar (1). Shift the twine bar in the slot
until the dimension "
b" = 2–5 mm .
The setting for the distance at the side "a" is adjusted
at the control rod assembly (5) for the twine bar (1). To
make the adjustment undo self-locking nuts (6) and
take off the ball head (7). Twist the control rod until the
dimension a is set at
a = 0 – 5 mm. Wenn der Garnrie-
gel in Richtung Kanalschlitz gedrückt wird, muß das
Maß
"a" noch eingehalten werden. Tighten up the self-
locking nuts again.
If the twine bars (1) are in the middle of the openings,
the distance from the tip of the twine bar and the inner
side of the needle (2) must be
"b" = 2–5 mm.
6.3.1 Adjusting the Twine Bar
Initiate the binding process manually (see chapter 5.4.4
"Initiating the Binding Process Manually"). Turn the
flywheel in the working direction. The needles move
upwards. At the same time move the twine bars over
the openings through which the needles transport the
twine to the knotter.
6.3 Twine Bar
The twine bar (1) draws the twine down from the needle
and presses it against the knotter hook. If the twine is
not taken by the twine bars, the knotter hook cannot
take up the twine.
BP-VFS-020
1
1
2
BP-VFS-021
3 4
1
BP-VFS-022
4
3
1
BP-VFS-023
5
6
7