Krone Big Pack 127 / MultiCut, Руководство по эксплуатации, Страница: 72 / 132

VII - 2
Care and Maintenance
7.3 Cleaning
The big pack baler, in particular the knotter, must be
cleaned of chaff and dust every time it is used. Under
very dry working conditions clean several times a day.
Ebenfalls täglich die Raffersteuerung und das
Schwungrad von Spreu und Staub reinigen.
• Repair work on the tyres may only be carried out by specialists with suitable mounting
tools.
• Park the big pack baler on firm level ground. Secure from unintentional rolling away using
wheel chocks and by applying the parking brake.
• Check regularly that the wheel nuts are fastened tightly and tighten up if necessary.
• Do not stand in front of the tyre when inflating with compressed air. The tyre can burst if the
pressure becomes too high. Risk of injury!
• Check the tyre pressure regularly.
7.4 Tyres
Observe the order of tightening and loosening wheel
nuts shown in the adjacent diagram. Check the wheel
nuts 10 operating hours after mounting and tighten up if
necessary. Subsequently check every 50 operating
hours that they are fastened tightly.
7.5 Opening the Front Guard Plate
The front guard plate (2) is unlocked using a Schrau-
bendreher (1). Engage the flywheel brake. Schrauben-
dreher in die Öffnung einführen und den Riegel nach
hinten schieben. As soon as the front guard plate is
unlocked it can be swung upwards.
When opening the front guard plate make
sure that it does not hit any part of the
machine.
Move the lever of the flywheel brake to
the stop position.
Thread
M18 x 1,5
M20 x 1,5
Spanner
size
24
27
Max. torque
black
265
343
M
A
(Nm)
zinc-plat.
245
294
Check the tyre pressure at regular intervals and inflate if
necessary. The tyre pressure is dependent on the tyre
size. The values are listed in the section
"Technical
Data".
BP 380-7-074
8
1
3
5
7
2
4
6
BP-VFS-030
1
2