Krone Big Pack 127 / MultiCut, Руководство по эксплуатации, Страница: 93 / 132

XII - 1
Special Equipment
12.1 MultiCut cutting system
The following always applies for all maintenance, assembly, repair and adjustment work:
• Bring the machine to a standstill.
• Switch off the engine and remove the ignition key.
• Secure the tractor and the Big Pack baler from rolling away.
• Secure the pick-up against intentional lowering.
• There is a high risk of injury when fitting and removing the blades. Only touch blades
with suitable gloves.
• Engage the flywheel brake.
12.1.1 Special notes on safety
12.1.2 General
The Big Pack MultiCut has a cutting system with a cutting
roller and fixed blades.
Cutting allows better bale processing and increased bale
density. The blades can be swung out of the conveyor
channel hydraulically from the tractor if there are blockages.
The machine can also be used without blades. The cutting
roller then takes over the conveying function between the
pick-up and pre-baling channel.
The Big Pack MultiCut 88 cutting system can be equipped
with a max. of 15 blades. The Big Pack MultiCut 128 and
Big Pack MultiCut 127 cutting system can be equipped
with a max. of 25 blades. Theoretically cutting length is 45
mm (Adjustment "45" on the selector disc). A cutting
length of "90 mm" can be achieved with two of the blade
sets. The cutting length can be read off the selector disc
(1).
The cutting length is determined by the number of
blades used:
• Big Pack MultiCut :
Cutting length Number of blades Setting
BP 88
BP 127/128
– 0 0 "0"
45 mm 15 25 "45"
90 mm 8 13 "90"
90 mm 7 12 "90"
12.1.2.3 Setting the cutting length
1
"0"
BP380-7-103
BP380-7-104
The setting is made on the left-hand side of the
machine using a special spanner (1). The spanner is on
the left-hand side of the machine in the twine box (2).
Blades have to be removed for a greater cutting length.
12. Special Equipment