Kozi BayWin, Руководство пользователя

Страница: 23 / 32

Page 23
Before each heating season:
1. Clean the venting system. If there is a significant amount of soot build
up, it should be removed to prevent the risk of a chimney fire. By
making sure the exhaust venting system and the heater itself are being
maintained properly and are cleaned on a regular basis, you reduce the
likelihood of a chimney fire occuring. Please contact your local
building or fire officials in your area for information on how to handle
a chimney fire. Have a plan of action ready incase a chimney fire
occurs.
2. Clean behind the back heat shield and exhaust passage. Ashes can
build up behind the back heat shield and inside the exhaust passage.
To remove the back heat shield you must remove 4 bolts located at
each corner of the heat shield. Using a brush, remove all of the ashes
that have built up on the back wall of the combustion chamber, on the
inside of the heat shield as well as in the exhaust passage (located
below the auger chute). Inspect the auger chute gasket at this time.
Make sure the gasket is still in good condition and that it is in the
original position when the back heat shield is bolted back into position.
3. Clean the exhaust fan and housing. Ash accumulation on the fan
blades will reduce the life of your exhaust fan. Frequent cleaning will
help extend the life of this component. Refering to figure 18, open the
left side pannel to access the exhaust fan. Using a Common (flat head)
screw driver, remove the 6 sheet metal screws holding the fan motor to
the housing. Using a brush, clean all ash from the exhaust fan blades
and housing.
4. Inspect the condition of the door gasket periodically and replace it as
necessary. It is important to make sure the door gaskets are in good
condition. Gaskets in poor condition will not allow the door to seal
properly and the heater will not function as efficiently.
ALLOW THE HEATER TO COOL TO ROOM TEMPERA-
TURE AND UNPLUG THE HEATER BEFORE PER-
FORMING ANY MAINTENANCE.