Kozi BayWin, Руководство пользователя

Страница: 24 / 32

Page 24
6. Perform weekly maintenance.
Figure 18. Holes for screws on
the right side panel
Figure 19. Oil ports on a
circulation fan
5. Oil the circulation fan motor. To oil the motor bearings, the right hand
side panel must first be opened. This is done by removing the 2 screws
near the front of the stove as shown in Figure 18. Use a Robertson
(square head) or Common (flat head) screwdriver to remove the
screws. You will now be able to swing the panel open and access the
circulation fan. There are 2 oil ports located on the top of the motor,
one near the end and one near the fan housing as shown in Figure 19.
There may be rubber plugs in one or both of these oil ports. These
plugs must be removed prior to and replaced after oiling. Place a few
drops of light oil, such as sewing machine oil, in each port.
Weekly or more frequently if needed:
1. Pull and push the cleaning rod which is located in the center, above the
door. This will remove the ash deposits on the heat exchanger tubes.
The removed ash will fall on the top heat shield, located in the burn
chamber.
2. Lift the top heat shield. Remove it carefully as there may be a
significant amount of ash on it. Dump the ashes into the burn
chamber.
3. Using a brush, clean the top heat shield and remove it from the heater.
4. Remove the burn pot and burn pot stand and clean them thoroughly.
Make sure there are no ashes remaining in the burn pot stand and that
all the holes in the burn pot are clear. Place all ashes into a metal
container with a tight fitting lid.