Kozi BayWin, Руководство пользователя

Страница: 14 / 32

Page 14
8.3
KOZI
BayWin
®
Pellet Insert Installation
Please follow the following steps when installing a KOZI pellet insert:
1. Verify that the fireplace opening meets the insert’s minimum require-
ments.
Working from the exterior of the building:
2. Attach and seal the exhaust venting to the terminal using sheet metal
screws and high temperature (RTV) silicone sealant.
3. Insert the venting into the existing chimney and secure the terminal to
the chimney. Ensure that the venting and chimney are properly sealed.
4. If outside combustion air is being used, install the air intake as
necessary.
3. When installing an insert, a full height listed chimney liner must be
attached to both the insert flue collar and to the chimney top as shown
in figure 9A or a partial chimney liner may be attached to the insert
flue collar and extending a minimum of 6 inches into the chimney
cavity as shown in figure 9B. The junction of the chimney liner to the
seal plate must be properly sealed. This chimney liner must be
stainless steel.
4. A permanent metal tag must be attached to the back of the fireplace.
The metal tag will state the following “After removal of this pellet
insert, the fireplace must be restored to its original state for safe use”.
5. The fireplace can NOT be altered in any way except for the following
situations:
A. For installation of a chimney liner, the chimney damper may be
removed.
B. External trim pieces of a fireplace can be removed only if they do
not affect the operation of the fireplace upon removal and they can
be reassembled when the insert is removed.
8.2 Surround Assembly
The
KOZI
pellet insert surround can be seen in
Figure 11. The surround comes in 3 separate
pieces and needs to be assembled before being
attached to the heater. Layout the top and sides of
the surround on the floor as shown in figure 11.
Verify that each side piece mounting holes are
aligned with the top piece mounting holes. Using
the supplied 1/4” bolts, secure the side pieces to
the top. Your surround is now ready to mount to
the insert.
Figure 11.
KOZI
pellet insert surround