Konica Minolta MS 2000, Инструкция по установке и эксплуатации

Страница: 48 / 59

The preview window can be a very
useful tool and provides a range of
functionality that makes working
with the PS 7
The PS 7000’
comprised of t
Rulers – A horizontal ruler runs
along the top of the window
while a vertical ruler runs along
the left. Th
corner ind
measurement (inches or
centimeters) is currently being
used for the ruler. Left clicking
on this box will switch the form
of measurement between inches
and centim
The Windo e preview window itself represents the entire 17”x 23” scan area of the
PS 7000. Within the preview window will be an outlined rectangle. This outline represents
the actual area that the scanner is currently set to capture. This outline can be changed and
and most comm
e paper size drop-down box or the front panel of the PS 7000 itself.
to simply right click outside the box
and drag and drop the mouse to create the desired size scan area. At any time you can right
click on the inside of the box and drag the entire scan area anywhere in the 17” x 23”
window.
Scan Left / Scan Right Buttons – When the PS 7000 is set to scan in single Scan Mode
these two buttons will become enabled and the “Scan” Action Button ( see the Action
Buttons section below ) will change to a “Scan All” button. The Left/Right buttons can then
be used to scan only one side of the total scan area rather than scanning both sides at once
as would happen with the Scan All or Start button.
Brightness & Contrast Controls
This set of controls allows users to change the composition of the scanned image as detailed
below. Please note that when using the slider bars you may notice some light lag or resistance
and
000 easier and faster.
s preview window is
hree key components:
e box in the upper left
icates which form of
eters.
w – Th
manipulated in a variety of ways. The easiest
paper size from th on way is to select a preset
Once a paper size is selected it will be represented in the preview window. Users wishing
to have more control over the scan area can either resize the box or click-and-drag a new
rectangle. To resize the box first hover the mouse over an edge or corner until the mouse
pointer changes to a resize tool then hold down the left mouse button and drag that edge or
corner to the desired location. An even easier way is
s
-- this is normal and is due to the bi-directional communication between the driver
scanner.