Konica Minolta Drypro 832, Руководство по обслуживанию

Страница: 421 / 530

Chapter 17 Troubleshooting
17-33
F 8AA4 Application
error
Output Baud rate settings failed After replacing the control box, restore the settings
F
8AA5 Application
error
Other Rs232c settings failed
D 8AF0 Application
error
Shutdown from UPS Shutdown signal received from UPS due to power cut,
lowered voltage etc
F 9000 Application
error
Failed to read total version file The cause of this error is either software or hardware.
Either reset the error, or switch the power OFF/ON.
If this does not correct the problem, either upgrade the
software or replace the control box.
F 9010 Application
error
Failed to start network IF: fork()
F
9011 Application
error
Failed to start network IF: exec ()
F 9012 Application
error
Failed to start network IF: socket ()
F 9013 Application
error
Failed to start network IF: bind ()
F 9014 Application
error
Failed to start network IF: listen()
F
9015 Application
error
Failed to start network IF: select ()
F 9016 Application
error
Failed to start network IF: accept ()
F 9017 Application
error
Failed to start network IF: send ()
F 9018 Application
error
Failed to start network IF: recv ()
F
9019 Application
error
Failed to start network IF:
Communication timeout
F 9020 Application
error
Failed to start mechanical control IF:
fork()
F 9021 Application
error
Failed to start mechanical control IF:
exec ()
F 9022 Application
error
Failed to start mechanical control IF:
socket()
F
9023 Application
error
Failed to start mechanical control IF:
bind()
F 9024 Application
error
Failed to start mechanical control IF:
listen()
F 9025 Application
error
Failed to start mechanical control IF:
select ()
F 9026 Application
error
Failed to start mechanical control IF:
accept ()
F
9027 Application
error
Failed to start mechanical control IF:
send ()
F 9028 Application
error
Failed to start mechanical control IF: recv
()
F 9029 Application
error
Failed to start mechanical control IF:
Communication timeout
F 9030 Application
error
Failed to start print IF: fork()
F
9031 Application
error
Failed to start print IF: exec ()
Error
Level
Error
Code
Error
Message (Display
Characters)
Error contents Error Support: Service