Kongsberg Simrad CS90, Справочное руководство

Страница: 580 / 686

578
442700/A
In physics, interference is the phenomenon in which two waves superpose each other
to form a resultant wave of greater or lower amplitude. Interference usually refers to
the interaction of waves that are correlated or coherent with each other, either because
they come from the same source or because they have the same or nearly the same
frequency. Interference effects can be observed with all types of waves, for example,
light, radio, acoustic, surface water waves or matter waves.
https://en.wikipedia.org/wiki/Wave_interference — April 2016
Note
When you work in the
Installation
dialog box, you must always select
Apply
to save the
changes made on a page. You must do this before you continue working on a different page.
Details
Synchronization Mode
Choose which
synchronization mode to use.
For "slave" operation, a
remote system (for example
K-Sync or Simrad TU40 )
must be available to provide
trigger pulses.
For "master" operation, a remote hydroacoustic system (sonar, echo sounder) is
connected. This remote system must be set up in "slave" mode.
• Stand-alone
Synchronization is turned off.This synchronization mode is used if the CS90 system
is working by itself and with no synchronization required. This is the default
setting. The CS90 system operates using its internal ping interval parameters,
independent of any trigger signals arriving at the synchronization port.
The
Synchronization Delay
setting is not applicable when synchronization is
switched off.
• Master
Master mode is used if the CS90 system is going to act as the controlling unit in a
synchronized system. The peripheral hydroacoustic system(s) are only permitted to
transmit when enabled by the CS90 system. When
Master mode is selected, the
CS90 system will run using its internal ping interval parameters and send trigger
signals to the peripheral system(s).
This mode is unavailable if you set
Synchronization Port
to
Transceiver Auxiliary
Port .
Simrad CS90 Reference Manual