Kongsberg Simrad CS90, Справочное руководство

Страница: 206 / 686

204
442700/A
list of valid datagram formats, select the format(s) to be accepted by the CS90 system. For
each relevant sensor you must insert the offset values that define the its physical location
relative to the vessel’s coordinate system.
Note
Just making changes and selecting
OK
at the bottom of the page will not install anything.
Select what to install, define the relevant parameters, and then select
Add
.
Procedure
1 Connect the gyro (or other heading sensor) to an available communication port on
your computer.
This is described in the Installation Manual .
2 Open the
Setup
menu.
3 On the
Setup
menu, select
Installation
.
Observe that the
Installation
dialog box opens. This dialog box contains a number of
pages selected from the menu on the left side.
4 On the left side of the
Installation
dialog box, select
Sensor Installation
.
5 For
Sensor Type
, select Gyro to import information from a global positioning system.
6 Select which port you want to import the sensor information on.
7 If you want to check the communication parameters, select
Inspect Port
.
Note
You cannot make any changes here. To change the communication parameters, use
the
I/O Setup
page.
8 If you want to check that the peripheral system is transmitting data to the CS90 system,
select
Monitor
.
The
Port Monitor
dialog box provides one text box for incoming messages (
Rx Data
),
and one for outgoing messages (
Tx Data
). Use these boxes and your knowledge of the
data communication to investigate the datagrams. The
Port Monitor
dialog box is a
tool for debugging purposes. It is neither required nor intended for normal operation of
the CS90 system.
9 Type a custom name to identify the interface in other dialog boxes.
10 Select which datagram(s) you want to import from the sensor.
11 If relevant, specify a dedicated talker ID.
Simrad CS90 Reference Manual