R5 SUPREME AIS Installation Short
Instruction
7000 118-363 C1
R
5
S
U
P
R
E
M
E
A
I
S
RECOMMENDED PHYSICAL LOCATION
Please consult the complete system manual P/N: 7000
118-300 for physical location and mounting aspects of
the system units and the VHF and GPS antennas.
SYSTEM MODE
Important:
The R5 SUPREME CDU can be set up to
operate in different system modes,
AIS, Navigation or a
Combined AIS and Navigation mode.
This short instruction deals with AIS functions only. If
Navigation system functions are activated, additional
setup will be necessary.
This quick installation guide serves as a complement to
the standard manuals found on the documentation CD. It
is designed to give immediate access to essential
information when executing an installation and a
functionality test.
Installation of the R5 SUPREME AIS
Transponder System should always be carefully
planned and executed by skilled personnel.
for the latest news
regarding this and other Saab products. AIS equipment is
currently found under
saab.com/security/maritime-traffic-
management/traffic-management/
Our product pages also contains contact information to
our dealers and service stations world-wide and much
more
Physical
R5 SUPREME AIS Transponder
Size W x H x D: 227x77x192 [mm]
R5 SUPREME CDU
Size W x H x D: 255x140x84 [mm]
Gimbal Mount
Size W x H x D: 295x170x84 [mm]
Power
R5 SUPREME AIS Transponder
Input 12/24 VDC (Max 30 VDC)
Power Consumption: 20W (60W peak)
R5 SUPREME CDU
Input 12/24 VDC (Max 30 VDC)
Power Consumption: 13W
GPS Receiver (AIS internal)
Receiver: 50 CH
Frequency: L1 (1575.42 MHz)
Update Rate: 2 Hz
Position accuracy (SA off)
Position <2.5 m GPS (CEP, 50%)
Antenna feeding: 5 VDC
Electrical Interfaces
R5 SUPREME AIS Transponder
RS 422 Port
Default speed (bps)
Pilot In/Out
38400
ECDIS In/Out
38400
LR In/Out
9600
Sensor 1 In/Out
4800
Sensor 2 In/Out
4800
Sensor 3 In/Out
4800
Note: RTCM-104 corrections are accepted on any
of the ports above,
Signal connector RS422: 26 pin HD-SUB (M)
Signal connector I/O: 26 pin HD-SUB (F)
Ethernet connector: RJ45
Power connector: 4 pin ConXall (M)
GPS 50 ohm antenna connector TNC female
VHF 50 ohm antenna connector BNC female
R5 SUPREME CDU
RS 422 Port
Default speed (bps)
CDU Pilot In/Out
38400
Ethernet connector: RJ45
Power connector: 4 pin ConXall (M)
Cables (recommended)
VHF and GPS
RG214/U
Sensors e.g. Gyro
RFE-HFI 2x2x0.75 mm
2
Ethernet Cable
CAT-5
VHF Transceiver
Frequency 156-163 MHz
Output power 1/12.5 W
Channel bandwidth 25 kHz
Bit Rate 9600 bps
Intervals between position reports 1-180 s
Modulation FM-GMSK/GFSK
Transmitter 1
Receivers 3
Transceiver Sensitivity <-107 dBm
Environmental data
Protected environment (IEC 60945)
Operating temperature -15 °C to 55 °C
Compass safe distance
R5 SUPREME AIS Transponder
65 cm to standard magnetic compass
40 cm to steering magnetic compass
R5 SUPREME CDU
75 cm to standard magnetic compass
50 cm to steering magnetic compass
The R5 SUPREME AIS Transponder System is
compliant with the following Standards
IMO Performance Standard for AIS (MSC 74(69)
Annex 3)
ITU-R M. 1371-5
ITU-R M. 825-3
ITU-R M. 1084-5
IEC 61993-2 Edition 2
IEC 61162-1/2 Edition 4/1 (NMEA 0183, Version 4.0)
IEC 61108-1 Edition 2
IEC 60945 Edition 4
IEC 62288 Edition 2
IALA Guidelines on AIS
Specifications subject to change without notice
