.
OPERATION
TROUBLESHOOTING
REMOVAL, INSTALLATION OF BATTERY CABLE
1. Open battery cover (1).
2. Before removing the battery, remove the ground cable
(normally connected to the negative (-) terminal). If any tool
touches between the positive terminal and the chassis, there is
danger of sparks being generated. Loosen the nut of the
terminal and remove the wires from the battery.
3. When installing the battery, connect the ground cable last.
Insert the hole of the terminal on the battery and tighten the nut.
Tightening torque: 9.8 to 19.6 Nm (1 to 2 kgm, 7.2 to 14.5 lbft)
4. Close battery cover (1).
PRECAUTIONS WHEN CHARGING BATTERY
When the charging the battery, if the battery is mistakenly handled,
there is danger of explosion. Follow the precautions in "IF
BATTERY IS DISCHARGED (PAGE 3-180)" and the instructions
given in the charger manual, and always observe the following.
Set the voltage of the charger to match the voltage of the battery
to be charged. If the correct voltage is not selected, the charger
may overheat and cause an explosion.
Connect the positive (+) charger clip of the charger to the
positive (+) terminal of the battery, then connect the negative (-)
charger clip of the charger to the negative (-) terminal of the
battery. Be sure to attach the clips securely.
Set the charging current to 1/10 of the value of the rated battery capacity; when performing rapid charging, set
it to less than the rated battery capacity.
If the charger current is too high, the electrolyte will leak or dry up, and this may cause the battery to catch fire and
explode.
If the battery electrolyte is frozen, do not charge the battery or start the engine with a different power source.
There is a danger that this will ignite the battery electrolyte and cause the battery to explode.
Do not use or charge the battery if the battery electrolyte level is below LOWER LEVEL line. This may cause an
explosion. Check the battery electrolyte level periodically and add distilled water to bring the electrolyte level to
UPPER LEVEL line.
3 - 181
Содержание D475A-5E0
