- 32 -
Note: Connect the 24 VDC and 0 V to their correct connectors. Otherwise, the device does not function normally.
In addition, wrong wiring may cause operation failure and damage of the product. Always check wiring before turning on the device.
When connecting the electrostatic potential sensor: DTY-EPS01-EA-□LWB for the first time, connect the power connector only and
ensure that the green LED of the sensor body is correctly turned on. Then, turn off the device and connect the communication
connector.
If the device is turned on when the power of the electrostatic potential sensor has a reverse connection, the device may be
damaged.
Note: When inserting a cable to each screwless terminal connector, use a Phoenix contact's screw driver SZS 0,4X2,0 (size: 0.4 x 2.0 x
60 mm) or an equivalent product.
Note: Do not connect to the terminal symbol NA (FG) connectors. If different voltage is supplied, the product may be damaged,
Note: Measurement value may be affected if dust adheres to the dust passage hole of the dust sensor. If dust is adhered to the dust
passage hole, removed the fan filter on the OUT side and clean the hole section with air. Life span of the LED used in the dust
sensor is limited. Light output will weaken over time when turned on (by less than 5% per 5 years).
4-2-6. Connecting communication devices
When a communication device such as a PC is connected, connect a USB-RS458 converter (IBM2A-H1-□) to the
communication connector (485IN),
When a daisy-chain connection is used, connect a daisy-chain cable (DTY-EPP-CG-□) to the communication connector
(485OUT), and connect to the communication connector of the next blow unit (485IN).
Connect a terminating resistor connector (IBFL-K-TR) to the communication connector of the last blow unit (485OUT).
For details of communication, refer to "6. Communication".
Note: When connecting the communication cable for the first time, ensure that the Power (green) LED of the blow unit successfully
turns on and turn off the light before connecting the cable. If the device is turned on when the communication cable or USB-
RS485 converter is connected while the power has a reverse connection, the device may be damaged.
PC
Communication connector
(
485OUT
)
Communication connector
(
485IN
)
Daisy-chain cable
DTY-EPP-CG-□
USB-RS485 converter
IBM2A-H1-□
Next blow unit
Terminating resistor connector
IBFL-K-TR
Содержание ION WIPER DTY-WB01
