Chapter 6
GTD-110/150
Using the menu
6-28
0093151542-06
6.10.1.2 DRAWING (Drawing a graphic using the cross cursor)
To draw a graphic instantly without knowing the precise location in latitude and longitude, use the
drawing method by the cross cursor. To do so:
(1) In the DRAWING menu, select a DRAWING BLOCK number (1 – 7).
(2) Select LINE THICKNESS, THIN or THICK.
(3) Select CURSOR as an INPUT METHOD.
(4) Select a line color using the COLOR (MARK) select switch.
(5) Press the ENT key. The chart display and the DRAWING (CURSOR) window will appear.
(6) Move the cross cursor onto a starting point and press the CUR key. The starting point will be
entered.
(7) Move the cursor to the first node and press the ENT key to fix. Repeat this procedure for other
nodes. If you enter a node position by mistake press the CANCEL key. Each time this key is
pressed, the entered block number returns to the previous number.
(8) To finish drawing, press the MENU key.
(9) Maximum number of nodes including the starting point is 500. To assign more nodes, temporarily
exit this sub menu by pressing the MENU key and restart.
(10) Assign a new block number among 500, which can be overwritten. You can change the color any
time during this operation.
6.10.2 DRAWING ERASE
(1) Select DRAWING ERASE in the DRAWING EDIT sub menu as shown in Figure 6.3.
(2) Move the cross cursor on to any node on the drawing. (NOTE: The selected node will be
Figure 6.33 Drawing lines
NOTE: If you enter a block number by mistake, press the CANCEL key. Each press of this key
brings the block number back by one.
Similarly, if you enter data by mistake, press the CANCEL key.
