Chapter 4 GTD-110/150
Installation
4-8
93151542-00
4.7.1 Pinouts of connectors on the rear panel
4.8 Inspections after installation
Before you turn the unit on, check the following points to make sure the GTD-110/150 operates
properly.
(1) Is the ship’s supply voltage and current within the rated range?
(2) Is the transducer wiring normal? No wrong connections, no short circuits, etc?
(3) Are the cables routed and connected properly according to Para. 4.5 “Cable routing and
connections”?
NOTE
Connecting an existing GPS/DGPS sensor to the GTD-110/150 Track Display
The GTD-110/150 series of Track display has a waterproof design, meeting the requirements of IPX-5
(Resistive against driven water). In order to maintain this specification, all the connectors used in an
existing external sensor must be replaced with waterproof type connectors as follows:
For DGPS sensor (KBG-2) and GPS sensor (GPS-10A): Replace the connector with the waterproof
type LTWD-06BFFA-L180 connector.
For detail, please contact KODEN or nearest KODEN service agent.
Figure 4.11 Pinouts of connectors on the rear panel
1. GND (OUT)
2. GPS
(OUT)
3. GND
(OUT)
4. GPS IN+ (IN)
5. GPS IN- (IN)
6. +12V
(OUT)
J5
1
2
3
5
4
6
J2
1
2
3
5
4
6
1. Ground
(GND)
2. Serial Output (TX)
3. Serial Output (GND)
4. Serial Input + (RX+)
5. Serial Input – (RX-)
6. Not used (NC)
J4 (Not used)
1
2
3
5
4
6
7
POWER
1
2
3
5
4
1. DC
–
2. DC
+
3. NC
4. NC
5. Frame
G
d
J1
(Not used)
1
2
3
5
4
