Knauer Azura P 6.1L, Руководство пользователя

Страница: 41 / 69

KNAUER P 6.1L User Manual V6890 Version 1.2
42 Troubleshooting
"Cannot operate with an
empty link" Create a link.
"Cannot purge during the
run" End method and start purging.
"Cannot read data from
FRAM" Switch the device off and on. If
this system message occurs
repeatedly, contact the Techni-
cal Support.
"Cannot start time table" Check the data on the device's
display or in the opened pro-
gram.
"Cannot use non-existing
component" Check if the channels to be
mixed are set correctly in the
Setup section of the device or in
the Instrument Setup of the chro-
matography software.
"Cannot write data on
FRAM" Restart the device. If this system
message occurs repeatedly, con-
tact the Technical Support.
"Component settings not
compatible with gradient
setup" Change the Setup settings or
change the gradient in the pro-
gram or in
Setup .
E "Error input activated" Eliminate the short circuit con-
nected to ‘Error In’.
F "Flow max in the program
is not compatible with the
current pump head" When entering the flow, note
the maximum flow of the pump
head and only enter values
inside this range.
G "GUI communication

failed"
Restart the device. If this system
message occurs repeatedly, con-
tact the Technical Support.
H "HPG B component not
present"
"HPG B: Command time-
out"
"HPG B: incompatible
pump head type"
"HPG B: Service active"
I "Instrument remote

controlled"
This entry is not executable.
Quit software.
"Invalid index in time
table" Change the entry in the pro-
gram line.
"Invalid line number"
"Invalid link" Create a link or use an existing
link.
System message