Kenworth T410, Руководство водителя

Страница: 321 / 418

CAT: 8612 November 2019 Page 295
PREVENTIVE MAINTENANCE
Transmission and Driveline
Substituting different transmission or drive-line components, other than
design-specified units, may result in increased vehicle noise emission.
Hood Insulation Blanket
Check all fasteners for condition and security. Repair or replace any broken
or defective fasteners.
Check for chafing, tears etc. Patch if necessary. Determine cause of
damage. If any component or accessory is causing wear or damage and
can’t be relocated, place reinforcing pads on the blanket at the wear spots.
Inner Fender Shields and Cab Skirts
Check all fasteners for security, particularly the self-tapping hex-head
screws. Remove and replace any loose rivets.
Check shields and skirts for cracks of mounting stress points. Check
fender shields for tyre marks, worn spots or damage from objects thrown
from tyre treads. Cracked or damaged fibreglass fender shields can be
repaired with fibreglass and resin.
If damage is found at a fastening point, additional strength can be gained by
using a suitable reinforcing plate, drilled to accept a rivet and laminating it
to the shield with fibreglass and resin. Cab skins, sills and brackets should
be checked for overall condition, and repaired as necessary. This work
can be accomplished at an authorised Kenworth dealership.
Damaged rubber fender shields or cab skirting must be replaced.