Kenworth T410, Руководство водителя

Страница: 314 / 418

Page 288 CAT: 8612 November 2019
PREVENTIVE MAINTENANCE
REAR AXLE LUBRICATION
Check oil level with the vehicle parked on level ground and the fluid warm.
The level should be even with the bottom of the filler hole.
Do not mix lubricants of different grades, although mixing different brands of
the same grade lubricant (meeting MIL-L-2105-C) is acceptable. Lubricants
of different grades are not compatible and could damage the axle.
In all cases, the lubricant supplier assumes full responsibility for the
performance of their product and for product and patent liability.
DANA REAR AXLE
Petroleum-based lubricants must be drained within the first 10,000km if
converting to an approved synthetic lubricant.
For recommended types and brands of lubricants, contact your Kenworth
dealer or authorised service centre. See the Kenworth Maintenance
Manual and the axle manufacturer’s Service Manual for further information
on servicing drive axles.
Initial Change - See Recommended Maintenance Schedules (pages
315 - 342), for standard rear axle service schedules. Change mineral-
based lubricant in other Dana axle assemblies (new or rebuilt) within the
first 10,000km.
For petroleum-based axles, use lubricants meeting MIL-L-2105-C/D grade
specifications or approved synthetic lubrication. Do not use oil additives.
All Vehicles with Dana Axles - See TRSM 0670 service manual in the
electronic Customised Maintenance Manual. Contact your Kenworth dealer
or authorised service centre for approved synthetic lubricant brands.
MERITOR REAR AXLE
See Meritor Lubrication Maintenance Manual (MM1) in the electronic
Customised Maintenance Manual.
On-Off Highway - Check every 250 hours of operation.
Change every 2,500 hours of operation thereafter or yearly whichever
occurs first.
AXLE HOUSING BREATHER VENT (ALL AXLES)
Check and clean the axle housing breather vent at each oil level check.