![background image](http://html1.mh-extra.com/html/keithley/dda-08/dda-08_user-manual_661637045.webp)
3-14
Setup and Installation
The following sections describe how to set these switches.
Note:
Ensure that the analog output range for a quad DAC, which you set
using switch settings is the same as the output range that you configure
using DriverLINX.
Setting the Output Signal
DDA-08/16 boards are shipped with the output signal for all quad DACs
set to voltage output. If this is not appropriate for your application, you
can reconfigure the output signal for a quad DAC using four 2-position
output signal switches.
Note:
For a particular quad DAC, all four output signal switches must be
set to the same output signal.
The output signal switches are labeled as shown in Table 3-4. Note that
the DDA-08 board does not contain the output signal switches for quad
DAC2 and quad DAC3.
Note:
The DDA-08/16 board is calibrated at the factory for
voltage
mode
. If the board is to be used in
current mode
, it needs to be
recalibrated.
Table 3-4. Output Signal Switches
Quad DAC
Labels
Quad DAC0
S10 to S13
Quad DAC1
S14 to S17
Quad DAC2
S18 to S21
Quad DAC3
S22 to S25
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com