Kathrein UFS 913, Руководство по эксплуатации

Страница: 20 / 64

20
Connection and set-up
DiSEqC™ Repeat:
The setting for how often the DiSEqC™
command must be repeated depends on
the con
fi guration of your reception system.
- Off DiSEqC™ command is not repeated
- 1 DiSEqC™ command is repeated once
- 2 DiSEqC™ command is repeated twice
- 3 DiSEqC™ command is repeated three times
22 kHz Control:
You only need to specify this data if your LNB type is “Simple”. The 22 kHz signal is needed to switch LNBs
when using multi-feed reception and to switch between Low and High band.
- On
- Off
Test-Transponder:
Select the selection fi eld “Test-Transponder”. Here you can select a transponder for checking whether
your settings are correct using the signal strength bar and signal quality bar.
When you have completed all settings for this satellite, press the

(green) button.
If you have selected more than one satellite (max. four) for Tuner 1, the receiver will automatically skip to
the settings for the second satellite. Now de
fi ne the settings for the second satellite, followed by the third
and fourth satellites as required, in the same way as described for the fi rst satellite.
Once all settings for all the satellites that you selected have been completed, the receiver will automatically
skip to the settings for the second tuner (assuming that for the second tuner you selected the connection
type “Separated” and set the signal con
fi guration to “Different from Tuner 1”). If this is the case, now de fi ne
the settings for the second tuner in the same way as you did for the fi rst tuner.
Once you have completed the settings for both tuners and the satellites assigned to them, the receiver
will automatically display the screen for the channel search. Continue the
fi rst installation with the
“Channel Search” section.
Refer to the documentation
for your reception system
or seek assistance from a
specialist engineer.