CAN RANGER III INSTALLATION
24
the transmitter and the
Auxiliary 2 output on the
receiver. When ACT3 is
selected, you must be
operating this actuator in
order to turn on the AUX 2
(LIGHTS) output. Otherwise
enable or disable it. If you
leave it enabled but do not
have the feature, you will get
an error indicating that there
is an output error. No damage
will occur. When you have
made your selection, press
<SET>.
Next is the Units setup. Use
↑
or
↓
to toggle between
ENGLISH and METRIC for the
actuator diagnostic screens.
When you have selected the
units of measurement you
want, press <SET> again.
Next is the HORN LOGIC
setup.
WARNING: Per ANSI standards,
it is the responsibility of the
operator to press horn to
operate the crane. This feature
is factory enabled to make sure
the operator pushes horn
before operating the crane.
Disabling this function will
leave the responsibility solely
on trained crane operator.
Use
↑
or
↓
to toggle between
ENABLE or DISABLE for the
HORN LOGIC. When Enabled,
the HORN button needs to be
pushed, along with an ENABLE
button for 1 second before
any joystick functions can be
activated. This needs to be
repeated if no joystick
functions are operated for
more than 1 minute. If
Disabled, only the ENABLE
button needs pressing to
