CAN RANGER III INSTALLATION
4
a.
Screw valve rod end to each of the actuators as shown (FIG.
3b)
b.
Attach clevis hardware to each valve rod end (FIG. 3c)
c.
Attach clevis hardware to each control arm tab as above
d.
Be sure each actuator is extended halfway out
e.
Measure and cut the rod to span between clevis ends
installed previously
f.
Remove one clevis end from each actuator and install
connecting rods and two jam nuts. Make sure the clevis end
on both the actuator and the valve rod is lined up to prevent
binding.
g.
Use manual control handles and check for proper operation
and no binding issues. Tighten up the jam nuts.
h.
Dress cables as shown in FIG. 4
i.
Remove drain plugs per decal instruction.
FIG. 3a
FIG. 4
FIG. 3b
FIG. 3c
