CAN RANGER III INSTALLATION
21
PWM generates a pulse width
modulated output with
amplitude of B on
RPM+ output. The percentage
of time that it is connected to
is the Duty Cycle.
The engine should have a
pull-down resistor in its input.
The parameters are MAXIMUM
PWM (Full throttle), MINIMUM
PWM (Idle) and FREQUENCY.
INVERTED PWM generates a
sinking pulse width modulated
output that is either
connected to ground or is
open on RPM+ output. The
percentage of time that it is
connected to ground is the
Duty Cycle. The engine should
have a pull-up resistor in its
input. The parameters are
MAXIMUM PWM (Full throttle),
MINIMUM PWM (Idle) and
FREQUENCY.
Analog generates a DC
voltage that varies to change
the engine’s RPM on Analog
output. The parameters are
MAXIMUM RPM (Full throttle),
and MINIMUM RPM (Idle).
To change parameters, use
the
←
and
→
buttons to
change digits. Use the
↑
and
↓
buttons to change the
selected digit’s value. Press
<SET> to save.
Actuator uses a CAN
Actuator to control the
throttle. For example it may
pull a cable connected to the
accelerator pedal. Follow the
steps on the Display to set the
Idle and Max RPM positions.
When using the transmitter to
