CAN RANGER III INSTALLATION
14
transmitter is ON and the
joystick is in neutral (center
position). This position is
normally the valve handle in
its neutral position (Valve
center).
FAST POSITION
This is the position the
actuator moves to when the
transmitter’s in fast mode and
a joystick is pushed all the
way in one direction. This
position is normally the
maximum travel of the valve
handle.
SLOW POSITION
This is the position the
actuator will move to when
the transmitter’s in slow mode
and a joystick is pushed all
the way in one direction. This
position is normally slightly
below the maximum travel of
the valve handle.
ENGINE STOP POSITION
This is the position of the
valve handle right before
hydraulics flow or function
movement. The receiver
commands the engine to stop
if the transmitter is ON with
joystick in the center and
valve is moved manually or
the actuator did not return to
center due to mechanical
failure or binding of the valve
components or actuator.
Move valve handle until there
is a slight motion of the boom
or winch function to store
value.
At the end of the calibration of
each actuator, the Auto
