CAN RANGER III INSTALLATION
25
activate joystick functions.
The default is Enabled.
Next is the enabling or
disabling of the following
outputs error codes: START,
STOP, HORN, RPM+, and RPM-
. Use
↑
or
↓
to toggle
between ENABLE or DISABLE
for the output’s error code.
When Enabled, the receiver’s
red LED will blink an error if it
detects a problem with that
output. When it is Disabled,
the receiver’s red LED will not
blink an error if it detects a
problem with the output.
Next is Joystick Enable setup.
Use
↑
or
↓
to toggle between
ENABLE or DISABLE for the
JOYSTICK ENABLE LOGIC.
When Enabled, the ENABLE
button needs to be pushed for
1 second before any joystick
functions can be activated and
then continually pressed. If
Disabled, the ENABLE button
needs to be pushed for 1
second before any joystick
functions can be activated.
This needs to be repeated if
no joystick functions are
operated for more than 15
seconds. The default is
Enabled.
Lastly the two Reach Error
parameters need to be set.
The CAN Actuators will detect
when they either cannot move
to their commanded position,
or if something moves them
away from their commanded
position. The CAN Actuators
will fight against this external
force for REACH ERR TIME. If
the CAN Actuator is more than
REACH ERR WINDOW distance
from the commanded position
