CAN RANGER III INSTALLATION
13
The receiver is programmed
for default values for each
actuator at the factory.
Please refer to Appendix B for
factory setting values.
PLEASE NOTE: IF THE
FOLLOWING PROCEDURE IS
NOT PERFORMED PRIOR TO
OPERATION, THE ENGINE STOP
MAY BE ON CONTINUOUSLY!
ACTUATOR CALIBRATION
USING THE MANUAL
HANDLES
Using the buttons on the CAN
Ranger Receiver, navigate
through the screens to
CALIBRATION. Press <SET>.
Use the arrow buttons to
enter the password 1262.
Enter the password by
pressing <SET>. Then select
the ACTATOR SETUP option by
pressing
↓
arrow button then
<SET>:
ACTUATOR SETUP
Setup Actuators Main Screen
Select the actuator you would
like to calibrate from the list
using the
↑
arrow,
↓
arrow,
and <SET> buttons. The
screens will then walk you
through the setup.
During the calibration you will
be asked to calibrate center,
fast, slow, and engine stop
positions. These positions are
defined as follow:
CENTER POSITION
This is the position the
actuator moves to when the
