Juniper QFX10016, Руководство по оборудованию

Страница: 362 / 439

syncing disks... All buffers synced.
Uptime: 11h0m30s
Normal shutdown (no dump device defined)
unloading fpga driver
unloading fx-scpld
Powering system off using ACPI
kvm: 28646: cpu0 disabled perfctr wrmsr: 0xc1 data 0xabcd
pci-stub 0000:01:00.2: transaction is not cleared; proceeding with reset anyway
pci-stub 0000:01:00.1: transaction is not cleared; proceeding with reset anyway
hub 1-1:1.0: over-current change on port 1
Stopping crond: [ OK ]
Stopping libvirtd daemon: [ OK ]
Shutting down ntpd: [ OK ]
Shutting down system logger: [ OK ]
Shutting down sntpc: [ OK ]
Stopping sshd: [ OK ]
Stopping vehostd: [ OK ]
Stopping watchdog: [ OK ]
Stopping xinetd: [ OK ]
Sending all processes the TERM signal... [ OK ]
Sending all processes the KILL signal... [ OK ]
Saving random seed: [ OK ]
Syncing hardware clock to system time [ OK ]
Turning off swap: [ OK ]
Unmounting file systems: [ OK ]
init: Re-executing /sbin/init
Halting system...
System halted.
CAUTION: The final output of any version of the request system halt command is the
“The operating system has halted.” Wait at least 60 seconds after first seeing this
message before following the instructions in Step
4 and Step 5 to power off the switch.
3. Attach the grounding strap to your bare wrist and to one of the two site ESD points on the chassis.
4. Disconnect power to the switch by performing one of the following tasks:
• AC power supply—Set the enable switch to the OFF (O) position and gently pull out the coupler
for the power cord from the faceplate.
• DC power supply—Switch the circuit breaker on the panel board that services the DC circuit to
the OFF position.
5. Remove the power source cable from the power supply faceplate:
351