D*AP4 VAP
72
You are able to create a new preset event by pressing
<create event>
:
Event name
[John Wayne]
A unique name to address this preset
event later in the action manager.
.
Use Settings from
[ON Air / Existing Event / Empty]
On Air
The events manager will
copy
all
On Air parameters
to
new
presets
in
all
function blocks (that have been
selected via the "Include these
Blocks" check boxes).
.
Existing Event
The presets of the selected event will
be copied to the new event and may
be marginally tuned afterwards to
form a slightly different event.
Empty
Creates a set of empty fields where you may select the preset of
your choice for the respective function block or leave it empty if no
changes are needed …
Include these Blocks
[System / Interface / Routing / Audio Processor / Voice 1 / Voice 2 /
Program / Monitor]
You can tell the event manager which function blocks must be
included in this event (or not).
Important note!
This is the way to create your own
snap shot
. The new presets will be automatically
given the name of this event! So be careful to select meaningful names. You will find them later on in your
function blocks!
Setup GUI – EVENTS – Events –
Parameter Events
Parameter events are designed to change parameters when executing an action.
You define the parameter here:
Category
[Audio Processor / Measurement]
Subcategory
[in case of Category = Audio Processor >> On Air Tools]
[in case of Category = Measurement >> Loudness]
Parameter
depending on the pre-selected Subcategory you may define the
relevant parameter which you want to set.
Expression
If applicable, the value of the parameter that will be set if the
parameter event is triggered during an event action.
