D*AP4 VAP
30
Setup GUI – INTERFACES – SDI I/O interface –
Local Routing
The SDI interface comes with a local routing matrix to shuffle audio signals from and to the system (device)
(i.e. to and from the central device router) and from and to the physical de-embedders / embedders.
Below you see an example routing that sends all signals 1:1 from the physical de-embedders
[INTERFACE – SDI IN G2 CH3 … SDI IN G4 CH4] to the physical embedders [SDI OUT G2 CH3 …
SDI OUT G4 CH4]. The signals from the physical de-embedders [SDI IN G1 CH1 … SDI IN G1 CH4] are
sent to the device router [DEM 1 … DEM4] while the device router outputs [SYSTEM – SDI Embedder
EMB 1 … EMB 6] are routed to the first 6 SDI channels [SDI OUT G1 CH1 … SDI OUT G2 CH2]:
You must use the scroll bar to navigate through the matrix. In the upper left corner you can select between
the
ONAIR
and the
PRESETS
view of the matrix. On the
ON AIR
page you will also see the device signal
labels (see ROUTING section further below for details).
Channel Linking
[mono / stereo]
You can decide if the routing must be performed in mono or stereo mode
(where adjacent odd/even channels are routed at once).
You may select cross points by hovering with the mouse over the little squares and select / deselect cross
points with a left mouse button click. The color of the respective squares changes:
Mouse over
Color codes of cross points:
dark blue
Possible new cross point.
orange
You are about to reconnect a cross point.
grey
Cross point is not allowed
(i.e. routing will cause a loop and will not therefore be performed).
red
You are about to disable a cross point
An animated signal flow
will help you when navigating through the matrix.
