D*AP4 VAP
9
Important Note!
The gateway entry is optional but you must ensure that the gateway address matches the
network mask related to the device IP address!
If you are not sure simply leave it at
0.0.0.0
.
Enter new gateway, press ENTER to configure without gateway:
<Enter>
Changing Network configuration
The network configuration has been changed. Please reboot the device
to activate the new settings.
Select item 8:
Do you want to reboot the device ?
<ENTER>
Press small
"y":
Do you want to reboot the device ? y
<ENTER>
Rebooting the device ……..
After reboot has finished, the new IP configuration is active and will be displayed at the top of the
configuration menu.
Getting Started – IP setup
–
via web browser
* Read the
default IP address
printed on the label at the rear of the device.
* Set up network parameters of your PC to fit the default IP address of the
D*AP4 unit
(e.g. default IP +1 and net mask = 255.255.0.0).
* Connect the
D*AP4 VAP
with the PC either by a Ethernet patch or a cross over cable
(if the PC does not support Auto MDI-X) or via a switch.
* Open a browser and type the IP address of the
D*AP4 unit
into the URL field and press
<ENTER>
.
This will open the
AUDIO PROCESSOR
tab sheet of the GUI.
* Click on
<SYSTEM>
and afterwards the "
Admin"
tab:
Enter the desired network configuration and press
<apply>
