62
4.1-2
4.3-9
Operator’s Manual
Layout
4.3.4 Bead breaking device
The machine is fi tted with an Upper Bead Breaking Disk
and a Lower Bead Breaking Disk, which operate on
the corresponding wheel beads. Both the disk support
arms are fi tted with sensors that are required when
operating in AUTOMATIC MODE.
To activate the bead breakers manually, proceed as
follows:
• Check that the machine is in Manual Mode.
WA R N I N G :
T H E S E O P E R AT I O N S M AY B E
DANGEROUS SO OBSERVE THE SAFETY
INSTRUCTIONS SET OUT ON THE PLATES.
Upper Bead Breaker:
• Activate the lever (
4, Fig.4.1-2
) and hold it in the
forward position. The Upper Bead Breaker will move
upwards (
Fig.4.3-9
).
• Activate the lever (
4, Fig.4.1-2
) and hold it in the
back position. The Upper Bead Breaker will move
downwards (
Fig.4.3-9
).
• Release the command when the end stop is
reached..
Lower Bead Breaker:
• Activate the lever (
5, Fig.4.1-2
) and hold it in the
forward position. The Lower Bead Breaker will move
upwards (
Fig.4.3-9
).
• Activate the lever (
4, Fig.4.1-2
) and hold it in the
back position. The Lower Bead Breaker will move
downwards (
Fig.4.3-9
).
• Release the command when the end stop is
reached..
Note:
The command
can be released in any position
and the operation will be interrupted.
If the command is activated again, the
operation will be resumed from the same
position.
Nota:
The disks must not for any reason come into
contact with each other.
QUADRIGA 1000/BB
4
5
Содержание QUADRIGA 1000
Страница 118: ...118 QUADRIGA 1000 BB ...
Страница 130: ...130 Note Note Hinweis QUADRIGA 1000 BB ...
Страница 131: ...131 Note Note Hinweis QUADRIGA 1000 BB ...
