Joab EcoDrive LA, Руководство по эксплуатации и обслуживанию

Страница: 38 / 89

Slush Flaps
If a snow plough is equipped with slush flaps, they can be activated by pressing the following
icon
. This activates a set of rubber flaps that are lowered below the bottom edge of the
snow plough blade. They scrape up the slush on the road surface. This requires that the snow
plough is equipped with a slush flaps and that it is electrically connected to the system. This is
not standard equipment.
Work Lighting
The right lower work lighting on the vehicle can be activated when working with a side plough,
by pressing the following icon
, This must be ordered as an additional option, it is not stand-
ard.
Adjustable Hydraulic Flow - AHF
A separate return line must be used with this function. There must be a dedicated
supply line and a dedicated return line. Do not use a single line for both the supply
and return of the hydraulic fluid.
The CBW controller can be used to set and adjust a constant hydraulic feed to a tip-trailer. This
is not standard, it must be ordered as an extra option.
The hydraulic supply is not the same as tipping or lowering a trailer. When the trailer is simply
lowered or tipped, a hydraulic feed is provided only during the time the function is activated. In
contrast, the hydraulic supply is constantly fed to the tip-trailer and can be either increased or
decreased as required.
The hydraulic supply to a tip trailer is normally fed from the hooklift's connector on the back of
the vehicle.
The CBW controller is used to control the flow of hydraulic fluid to the tip-trailer. The flow is ini-
tially set at 0 l/min and must be set to the required value by the driver using the tip trailer icons.
Refer to
Table 9 , on page 31.
Once a value for the hydraulic supply has been set, using the tip-trailer icons, it is saved. If the
unit or power supply is turned off, the value is still saved. It can be changed again, if desired, at
any time. To reset the value, activate the function and use the icons to reset it.
After setting the continuous-hydraulic-supply, it can be started by simply selecting its icon, as
shown below. The hydraulic supply will flow at the saved rate of flow.
There is no hydraulic flow sensor in the supply line to the tip trailer. Therefore, an external flow
sensor will be required if the hydraulic flow is to be measured.
To operate the hydraulic supply to the tip trailer use the functions listed below.
30
Operation | EcoDriveOptional Functions
EcoDrive 2.0 manual: 1021970 Edition 1 | 2022-02-04