Joab EcoDrive LA, Руководство по эксплуатации и обслуживанию

Страница: 46 / 89

3. Verify that the display turn ON.
Fast Operation
To operate fast operation, simply press and hold button 4 down while operating the shunting or
tip function. Note, fast operation can not be used when tipping down.
Axle Weight Reading
The radio controller can be used to provide an approximate value for the
weight on an axle(s). Note, this is not a precise value and must be seen as
an indication of the actual weight only. This functionality must be ordered
as an extra option, it is not standard.
JOAB AB disclaims all responsibility if a vehicle is over weight, even if the
radio controller displays a value that is lower then the maximum allowed for
the vehicle.
The value displayed in the radio controller will normally be within ± 150 kg.
To activate the axle weight mode, press button 12 repeatedly, until a weight
scale is shown. To select which axles are included in the measurement,
press the respective buttons: 2, 4, 6, and 8 corresponding to the axle(s)
that are to be measured.
Each of the buttons (2, 4, 6, and 8) have two LEDs above them. These are
used to show which axles are selected and the status of the axles. The right
LED is illuminated red for axles that are selected, as shown. The left LED
will blink red whenever an axle is 0–500 kg less than the maximum allowed weight. The left
LED will constantly illuminate if an axle is over its allowed weight.
The LED above button 9 is used to indicate that it is the net weight that is displayed in the
screen. When the net weight is displayed, the LED is lit red. To change between the net weight
and the gross weight press buttons 9/10.
Charging
The charger for the radio controller is normally mounted
next to the driver's A-post inside the cab. Alternatively, it is
mounted in the driver's side toolbox, behind the door.
When not in use, always place the radio controller in its
charger. This will ensure that it is always fully loaded and
ready for operation.
To remove the radio controller from the charger, first pull
the bottom out a
small amount , approximately 10 mm,
and then push the controller up, as shown.
38
Radio Controllers | Operation
EcoDrive 2.0 manual: 1021970 Edition 1 | 2022-02-04