Joab EcoDrive LA, Руководство по эксплуатации и обслуживанию

Страница: 74 / 89

Torquing of Fasteners
All fasteners on the hooklift shall be re-torqued after 5000 km of operation. Vertical pendulum-
bolts shall be re-torqued to 40 Nm. All other bolts shall be torqued as stated below.
Threads Torque 8.8 Torque 10,9
M8 24 Nm 33 Nm
M10 47 Nm 65 Nm
M12 81 Nm 114 Nm
M14 128 Nm 181 Nm
M16 197 Nm 277 Nm
M18 275 Nm 386 Nm
M20 385 Nm 541 Nm
M24 518 Nm 935 Nm
Table 14: Torque values for fasteners
Working on the Hook-Lift
Before working on a raised hooklift, remove the body from the hooklift. The tip-sup-
port, as described below, must also be in place to support the hooklift. Failure to do
so, can lead to serious injury or death.
The hooklift is equipped with a tip-support, as
shown opposite. This must be used when work-
ing on the hooklift. It supports the hooklift
when it is raised and acts as a safety measure
in the event of a hydraulic failure.
Shown opposite is the location for storing the
tip-support (shown in red). It is stored on the
left inside of the sub-frame.
The correct placement of the tip-support when
working on the hooklift is also shown. It must
placed between the sub frame and the intermediate-section, using its anchor points, as shown
and described below.
66
Service and Maintenance | Working on the Hook-Lift
EcoDrive 2.0 manual: 1021970 Edition 1 | 2022-02-04