Joab EcoDrive LA, Руководство по эксплуатации и обслуживанию

Страница: 42 / 89

EcoDrive hook-lifts that have been fitted with
dowel-pins, as shown opposite, can be used to
load a crane body.
All crane bodies used with EcoDrive must fulfill
the following standard:
SS 3021:2014 .
The dowel-pins lock into corresponding
dowel-pin-housings on the body and ensure
that it is correctly secured onto the hook-lift.
The number of dowel-pins required is depend-
ent upon the crane's lifting capacity.
Table 10 below lists the number dowel-pins required in relation to the lifting capacity of a crane.
Crane Lifting Capacity (ton/meter) Dowel-Pins Required
16 2
22 4
28 6
Table 10: Crane lifting ability
Dowel-pins can be retro-fitted. For information regarding this please contact JOAB after sales
department.
Activating a Crane
Read and adhere to all safety warnings and operating instructions in the crane's oper-
ator manual before operating a crane.
To operate a crane the CBW controller must first be turned on and the crane icon activated
from within the CBW controller.
When the crane icon is activated, the PTO is turned on and electricity is supplied to the crane.
Once activated, a green pump icon
will be displayed in the top right-hand side of the
CB controller and the crane active icon is displayed above the function buttons.
Operation of the crane is done using the crane's own control unit. This is a separate device and
comes with its own operator manual. For information regarding the operation of the crane con-
troller, please refer to its manual.
NOTE: To prevent damage to the hooklift, it is not possible to tip the hook-lift when a crane
body is loaded. The hook-lift is normally fitted with a sensor that detects if a crane body is
loaded and prevents it from be tipped or shunted.
34
Operation | Crane Operation
EcoDrive 2.0 manual: 1021970 Edition 1 | 2022-02-04