Chapter 18 System Setting and Maintaining
156
CellAdvisor JD720C User's Manual
a
Tap the drop-down list button for the
Language
.
Default setting is
English
.
b
Select a language option from the drop-down list.
Available languages may vary depending on the country or region where the instrument
is purchased.
–
Power On:
Select the power-on option from the choices:
Preset
to boot up with factory
default settings and
Last
with the settings at the last power-off or shut-down of the
instrument.
–
Sound:
To adjust the volume, tap the volume input box and then enter a number between 1
and 10 by using the numeric keys or the rotary knob. To turn off the
Sound
for the key
strokes and alarms, select
Off
.
–
Display Mode:
Select the display mode option from the choices:
Indoor
,
Outdoor
, and
Night
. The instrument adjusts its display background and chart color properties to best fit to
each selection.
–
Sleep/Hibernate:
To set the amount of time for entering into power saving mode, complete
the following steps:
a
Tap the bar for the
Sleep/Hibernate
.
The pop-up window appears. Default setting is
Hibernate
with
40
minutes.
b
Touch the
Sleep Time
input box and then enter a number between
0
and
60
.
The sleep mode turns off the display backlight to save power.
c
Touch the
Hibernate
input box and then enter a number between
0
and
60
.
The hibernation mode puts the instrument into the standby mode to save power.
This setting is predominant over the sleep time setting.
d
Tap the
Apply
button.
–
Keypad Backlight:
Select the keypad backlight option from the choices:
Always On
to
illuminate the backlight always,
On
for a few seconds, and
Off
to turn it off.
–
LCD Brightness:
Touch the
LCD Brightness
input box and then enter a number between
1
and
10
by using the numeric keys or the rotary knob.
The larger you set the number, the brighter the display illuminates.
–
App Interface:
To select your preferred application interface protocol to remotely control
your instrument for each connection method, complete the following steps:
a
Tap the bar for
App Interface
.
The pop-up window appears.
b
Select the
LAN
app interface option from the choices:
App SW
to use an application
like JDViewer or JDRemote, and
SCPI
to use SCPI commands.
c
Select the
USB
app interface option from the choices:
App SW
to use an application
like JDViewer or JDRemote, and
TMC
to use USB TMC protocols.
d
Select the
UART
app interface option from the choices:
SCPI
to use SCPI commands
and
Other
to use other application software via RS-232C.
e
Tap the
Apply
button.
–
Trace Location:
To specify a new location to initially load trace data (
*.tra
) when using
JDViewer or other software, complete the following steps:
a
Tap the bar for the
Trace Location
.
The Trace Location window appears.
b
Highlight a folder or location other than the default
/Internal
.
c
Tap the
Apply
button.
4
Tap the
Apply
button in the lower-right corner of the screen to save the change(s) and return to
the measurement screen.
