![background image](http://html1.mh-extra.com/html/jcm/taiko-pub-7-11/taiko-pub-7-11_operation-and-maintenance-manual_3548619079.webp)
P/N 960-100175R_Rev. 4 {EDP #200824}
© 2013, Japan CashMachine Co., Limited
A - 3
TroubleShooting
Taiko™ Series Banknote Acceptor
Appendix A
Table A-2
Adjustment Fault Conditions
Symptoms/Error
Messages
Possible Fault Causes
Corrective Action Required
Adjustment Error
Wrong Reference Paper being
used
Use the correct KS-070 or KS-88 specified Reference Paper for
calibrating the Taiko Unit.
CPU and/or Sensor Board
Failure
Replace the CPU Circuit Board (See "CPU Circuit Board Removal"
procedure in Section 4 of this Service Manual). Once the CPU Circuit
Board is replaced, perform a complete Calibration Procedure (See
"Calibration Procedures” on page 6-7 in Section 6 of this Service
Manual).
Table A-3
Communication Fault Conditions
Symptoms/Error
Messages
Possible Fault Causes
Corrective Action Required
Cannot
communicate with the
Host Machine.
DIP Switch settings are
incorrect
Set all DIP Switches to OFF and re-apply power to the Taiko Unit.
Connectors are off
or loosely fitted
Firmly re-seat all of the Communication Connectors.
Damaged Connector Pin(s)
Check for any bent, missing or damaged Pins in the Connector Plugs and
mating Receptacles. Straighten or replace Pins or the entire Connector.
CPU and/or Sensor Board is
corrupted
Replace the CPU and/or Sensor Circuit Board (See "CPU Circuit Board
Removal" and "Sensor Circuit Board Removal” on page 4-2 of Section 4
in this Service Manual). Once the CPU/Sensor Board is replace, perform
a complete Calibration Procedure (See "Calibration Procedures” on
page 6-7 in Section 6 of this Service Manual).
Incorrect Interface
Verify that the correct interface between the Host Machine and the
Banknote Acceptor is being used. If wrong, reset the Interface DIP
Switches accordingly ((See "DIP Switch Configurations” on page 2-3 in
Section 2 of this Service Manual).
Table A-4
Taiko Usage Specifications (Part 1)
EDP No.
→
110871
139230
131655
110904
196601
Function
Model
Pin
Assignment
Interface
Input
Power
Source
Barcode
Sensor
ICA
(OEM)
Upper
Guide
Upper
Guide
Parallel
Mag
Head
Holder
Mag
Head
Roller
Barcode
Sensor
Block
PUB-7
Early
Version.
Serial
12V
-
-
O
X
O
O
X
Standard
Serial
12V
-
-
O
X
O
O
X
Standard
Serial
12V
Available
-
O
X
X
X
O
Standard
Serial
12V
-
Available
O
X
O
O
X
Standard
Parallel
12V
-
-
X
O
O
O
X
Standard
Serial
12V/24V
-
-
O
X
X
O
X
PUB-11
Standard
Serial
12V
-
-
O
X
X
O
X
Standard
Serial
12V
-
-
O
X
X
O
X
Standard
Serial
12V
-
Available
O
X
X
O
X
Standard
Parallel
12V
-
-
X
O
X
O
X
Standard
Serial
12V/24V
-
-
O
X
X
O
X