P/N 960-100175R_Rev. 4 {EDP #200824}
© 2013, Japan CashMachine Co., Limited
2 - 3
Installation
Taiko™ Series Banknote Acceptor
Section 2
2. Press-in on the Upper Lid Open/Close Buttons
and open the Upper Lid in the direction indicated
in Figure 2-9
.
3. Remove the jammed Banknote as illustrated in
.
Clearing a Lower Area Banknote Jam
When a lower area Banknote jam occurs, the Front
Panel
Red
LED Display will begin blinking four (4)
times with a pause between blink sets.
Perform the following steps to clear a Banknote
jam within the Taiko™ Unit’s Transport area:
1. Remove Power from the Taiko™ Unit.
2. Remove the Taiko™ Unit body from the mounted
Bezel Section (review removal instruction shown
in Figure 2-3 on page 2-1 of this Section).
3. Remove the Lower Lid by pressing-in on the
Lower Lid Lock Release Button (See Figure 2-10
).
4. Remove the jammed Banknote as illustrated in
.
DIP Switch Configurations
The communication method and various Taiko™
Unit functions can be selected by using the Unit’s
Left side set of DIP Switches (See Figure 2-11).
Table 2-2 lists the various typical DIP Switch set-
tings available for programing the Taiko™ Unit.
Table 2-3 lists the various special DIP Switch
settings available for programing the Taiko™ Unit.
Figure 2-9
Upper Area Banknote Jam Removal
Caution: When closing the Upper Lid,
be careful not to get your finger caught
under the Lid when closing it!
Figure 2-10
Lower Area Banknote Jam Removal
NOTE: Re-install the Taiko Unit onto the Bezel
by reversing the steps related to, and beginning
from Figure 2-6 on page 2-2 of this Section.
Table 2-2
Typical DIP Switch Settings
Switch
No.
Switch Position Setting
ON
OFF
1
Test Mode 1
*
*. For details concerning the Test Mode, refer to “Performance Test
Diagnostics” on page 6-7 in Section 6.
Normal Mode
2
Double Scan Mode
†
†. The acceptance rate will be improved, but operation time will be
increased if a Banknote (note) is rejected.
Normal Scan Mode
3
Reserved
Reserved
4
Five (5) Drum Rotation
Cycles
‡
(Anti-Fishing Prevention)
‡. Anti-Fishing prevention will be improved, but operation time will
increase.
Normal Operation
5
Refer to the specific Country’s Software
Specifications
6
7
8
Figure 2-11
Left Side DIP Switch Block Location
Left Side
ON
DIP Switch Block
ON
6
7
8
IF Setting
OFF
OFF
OFF
ID-003 Serial
ON
OFF
OFF
MDB
OFF
ON
OFF
ccTalk (Non-Encrypted)
ON
ON
OFF
ccTalk (Encrypted)
*
*. If the encryption code is unclear, refer to the “Encryption Code Initialization
Setting Mode” on page 2-5 of this Section to initialize the Encryption Code.
-
-
ON
Pulse
†
†. For detailed information concerning Communication Settings, refer to the
individual Country’s Software Information Sheet.
