P/N 960-100175R_Rev. 4 {EDP #200824}
© 2013, Japan CashMachine Co., Limited
2 - 6
Section 2
Taiko™ Series Banknote Acceptor
Installation
Cleaning Procedures
To clean the Taiko™ Unit, gently rub the Sensors
and Rollers clean using a dry, soft, lint-free cloth
ONLY.
Do not use any Alcohol, solvents, Citrus based
products or scouring agents that may cause damage
to the Validation Section Sensors and/or Rollers.
Sensor and Roller Cleaning Procedure
To clean the Taiko™ Unit, proceed as follows:
1. Turn the Taiko™ Unit and Host Machine’s Power
Supply’s
OFF
.
2. Open the Taiko™ Upper Guide Lid.
3. Clean
the
appropriate
path and Lens of each
Sensor (See Figure 2-21 areas “
a
” through “
k
”
and the corresponding descriptions listed in Table
2-9 to locate each Sensor that require cleaning).
Available Cleaning Card
A JCM Waffletechnology Bill Validator Cleaning
Card is now available (JCM Part No. 501-000252R,
Manufacturer’s Part No. KWJCM-B5B15M). The
Cleaning Card is designed to be used as a supple-
mental part of a Preventive Maintenance program
to help in reducing dirt and Paper dust build-up
within a Unit. This will optimize performance
between regular Preventive Maintenance intervals.
This is the only cleaning card authorized for use on
the Taiko (PUB-7/11) Validator (See Figure 2-20).
Card Features
•
A unique Waffletechnology design that hugs all
surfaces to insure complete surface cleaning
•
Specially designed scrubber patterns insure
that belts and O-ring Rollers are cleaned and
lubricated to prevent them from drying out.
Directions For Use
1. Remove Cleaning Card from pouch and insert it
into the Banknote Validator.
2. The Cleaning Card will be accepted and then
automatically returned.
3. Dispose of used Card in an environmentally safe
manner.
For more information and a list of Authorized
Waffletechnology Distributers visit:
http://www.jcmwaffletechnology.com
.
Table 2-8
Parallel ID-001 Interface Pin
Assignments
Pin No.
Signal
Name
I/O
*
*. I/O (Input/Output) is the function viewed from the Banknote Acceptor
Side.
Function
1
Vcc
-
+12V DC Power
2
Vss
-
+12V DC Power Ground
3
Vss
-
Power Supply Ground
4
NC
-
No Connection
5
ACK
IN
ACKnowledge Signal Receive Line
6
REJ
REJect Signal Receive Line
7
INH
INHibit Signal Receive Line
8
VALID
OUT
Vend VALID Send Signal Line
9
VEND1
VEND1 Valid Send Signal Line
10
VEND2
VEND2 Valid Send Signal Line
11
VEND3
VEND3 Valid Send Signal Line
12
NC
-
No Connection
13
NC
-
No Connection
14
BUSY
OUT
BUSY Signal Send Line
15
ABN
ABortNote Signal Line
16
STKF
STacKerFull Signal Line
Caution: Do not use Alcohol, thinner or
citrus based products for cleaning any
surfaces. The Lenses can become
clouded by chemical effect that may
cause acceptance errors.
Figure 2-19
Sensor Cleaning
Lens
Roller
Lint-free Cloth Cotton Swab Air
Before
Cleaning
After
Cleaning
Belt
Figure 2-20
JCM Waffletechnology Cleaning Card
New Cleaning Card
Cleaning Card Pouch