![background image](http://html1.mh-extra.com/html/jcm/taiko-pub-7-11/taiko-pub-7-11_operation-and-maintenance-manual_3548619044.webp)
P/N 960-100175R_Rev. 4 {EDP #200824}
© 2013, Japan CashMachine Co., Limited
4 - 2
Section 4
Taiko™ Series Banknote Acceptor
Disassembly/Reassembly
MAG Board Removal (PUB-11 Only)
The MAG Circuit Board is mounted in a PUB-11
Unit only below the CPU Circuit Board.
To remove the MAG Circuit Board, proceed as
follows:
1. Remove the Harness Connector and remove the
CPU Circuit Board as previously described dur-
ing “CPU Circuit Board Removal” on page 4-1 of
this Section.
2. Remove the two (2) Circuit Board Mounting
1
& a
2
) from the MAG
Circuit Board (See Figure 4-4 b).
3. Remove the MAG Circuit Board’s associated
short interboard Harness Connector (See Figure
4-4 c).
4. Remove the MAG Circuit Board from the Assem-
Sensor Circuit Board Removal
To remove the Sensor Circuit Board, proceed as
follows:
1. Remove the CPU Circuit Board as previously
described during “CPU Circuit Board Removal”
on page 4-1 of this Section.
2. Remove the two (2) Side Panel Mounting Screws
from the both the left and right side of the
Taiko™ Unit (See Figure 4-6 a
1
& a
2
).
3. Remove the Upper Lid (See Figure 4-7 a) and left
and right Side Covers (See Figure 4-7 b
1
& b
2
)
off of the Assembly.
4. Unplug the two (2) Harness Connectors
1
& c
2
) from both the left and
right sides of the Sensor Circuit Board Assembly.
5. Reverse Steps 1 to 4 when replacing the Sensor
Circuit Board.
Transport Drum Disassembly
To remove the Transport Drum and/or Feed Roller
Assemblies, proceed as follows:
1. Remove the CPU Circuit Board as previously
described during “CPU Circuit Board Removal”
on page 4-1 of this Section, and perform the pro-
cedure for “MAG Board Removal (PUB-11
Only)” on page 4-2 of this Section first if the Unit
is also a Taiko™ PUB-11.
2. Remove the Transport Drum (See Figure 4-8 a)
Unit from the Lower Base Assembly (See Figure
4-8 b).
3. Remove the six (6) Transport Drum End Cover
Mounting Screws (See Figure 4-9 a
1
through a
6
)
from the right and left end of the Transport Drum
Unit (See Figure 4-9 b).
4. Separate the Center Guide (See Figure 4-9 c
1
&
c
6
) from the two ends the direction indicated by
the Large Arrows in Figure 4-9.
c
a
1
a
2
b
Figure 4-4
Taiko MAG Circuit Board Disconnect
a
Figure 4-5
Taiko MAG Circuit Board Disconnect
c
a
1
a
2
b
a
1
a
2
Figure 4-6
Taiko Side Mounting Screw Removals
c
c
1
c
2
a
b
1
b
2
Figure 4-7
Upper Lid and Side Covers Removal