P/N 960-100175R_Rev. 4 {EDP #200824}
© 2013, Japan CashMachine Co., Limited
4 - 3
Disassembly/Reassembly
Taiko™ Series Banknote Acceptor
Section 4
5. Remove the Feed Roller Assembly (See Figure 4-
10 a
1
& a
2
) from both ends of the Center Drum
Unit Assembly (See Figure 4-10 b).
6. Remove the three (3) Washers (See Figure 4-10
c
1
through c
6
) from each end of the Center Drum
Unit Assembly.
7. Insert a small Flatblade Screwdriver or equivalent
into the encircled area shown in Figure 4-11a.
8. Twist and pry the upper portion of the Center
Guide Section up (See Figure 4-11 b), and
remove it from the Lower Center Guide Section
9. Remove the single (1) Prism Mounting Screw
(See Figure 4-12 a) and remove the Prism
(See Figure 4-12 b) from the Upper Center Guide
Assembly (See Figure 4-12 c).
10. Remove the two (2) Sensor Circuit Board Mount-
ing Screws (See Figure 4-13 a
1
& a
2
).
11. Slide the loose Sensor Circuit Board (See Figure
4-13 b) out through the side opening slit provided
to remove it from the Upper Center Guide
Assembly (See Figure 4-13 c).
Encoder Board and Drive Motor Removal
To remove the Transport Drum Encoder Circuit
Board and/or Drive Motor Unit, proceed as
follows:
1. Remove the CPU Circuit Board as previously
described during “CPU Circuit Board Removal”
on page 4-1 of this Section; preform the proce-
dure for “MAG Board Removal (PUB-11 Only)”
on page 4-2 of this Section, and disassemble the
Transport Drum as described in the Section titled
“Transport Drum Disassembly” on page 4-2 of
this Section. However, Steps 9, 10 and 11 of this
last procedure may be omitted.
a
b
Figure 4-8
Taiko Transport Drum Removal
b
Right End
a
1
a
2
a
3
a
4
a
5
a
6
Left End
b
c
1
c
1
Figure 4-9
Right & Left Transport Drum End
Cover Removal
b
a
1
a
2
c
1
c
2
c
3
c
5
c
4
c
6
Figure 4-10
Dual Feed Roller Assembly Removal
a
b
a
b
c
Figure 4-11
Transport Drum Separation
a
b
c
Figure 4-12
Upper Guide Prism Removal
b
c
a
2
a
1
Figure 4-13
Upper Guide Sensor Board Removal
