![background image](http://html1.mh-extra.com/html/jcm/taiko-pub-7-11/taiko-pub-7-11_operation-and-maintenance-manual_3548619043.webp)
P/N 960-100175R_Rev. 4 {EDP #200824}
© 2013, Japan CashMachine Co., Limited
4 - 1
S e c t i o n 4
This section provides disassembly and reassembly
instructions for the Taiko
™
PUB-7/11 Banknote
Acceptor Series. This section contains the follow-
ing information:
•
Tool Requirements
•
Primary Unit Disassembly
•
Acceptor Unit Disassembly
•
Transport Unit Disassembly
•
Cash Box Disassembly.
Tool Requirements
The following tools will be required to perform
disassembly and reassembly:
•
#1 & #2 Phillips Screw Driver
•
Medium Flatblade Screw Driver
•
Set of Jewelers Phillips Screw Driver
•
E-Clip (E-Ring) Pliers
•
Needle Nose Pliers.
Primary Unit Disassembly
The following instructions are provided to perform
an initial disassembly of the Taiko™ Banknote
Acceptor’s primary components.
Bezel Guide Removal
To remove the Bezel Guide, proceed as follows:
1. Remove the two (2) Bezel Mounting Screws
1
& a
2
) located behind the
Bezel Guide (See Figure 4-1 b).
2. Separate the Bezel Guide from its Front Bezel
3. Insert the new Bezel Guide into the exciting
Bezel and replace and tighten the two (2) mount-
ing screws that bind the Bezel to the Bezel Guide.
CPU Circuit Board Removal
To remove the CPU Circuit Board, proceed as
follows:
1. Insert a medium size Flatblade Screwdriver into
the gap located on the left or right side area of the
Upper Lid Cover (See Figure 4-2 a & b), and
gently lift the Cover up and off the Assembly.
2. Unplug the four (4) Harness Connectors from the
CPU Circuit Board (See Figure 4-3 a
1
to a
4
).
3. Remove the two (2) Self-tapping Circuit Board
Mounting Screws (See Figure 4-3 b
1
& b
2
)
retaining the Board in place.
4. Remove the Harness Connector (See Figure 4-3
c) located under the CPU Circuit Board
(See Figure 4-3 d) and lift the CPU Circuit Board
up and off the Assembly in the direction in-
dicated by the Large Arrow in Figure 4-3.
5. Reverse Steps 1 to 4 when replacing the CPU
Circuit Board.
4 DISASSEMBLY/REASSEMBLY
a
1
a
2
b
c
Figure 4-1
Taiko Bezel Guide Removal
WARNING: Tightening the nuts with too
much force can damage the Bezel. The
necessary torque is 0.513 foot-lbs (0.7Nm).
a
b
Figure 4-2
Taiko CPU Board Cover Removal
c
a
1
a
2
a
3
a
4
b
1
b
2
b
1
b
2
d
Figure 4-3
Taiko CPU Circuit Board Removal