JCM TAIKO PUB-7/11, Руководство по эксплуатации и обслуживанию

Страница: 46 / 84

P/N 960-100175R_Rev. 4 {EDP #200824} © 2013, Japan CashMachine Co., Limited
4 - 4
Section 4 Taiko™ Series Banknote Acceptor Disassembly/Reassembly
2. Remove the single (1) Motor Drive Assembly
mounting screw (See Figure 4-14 a) from the
Lower Center Guide (See Figure 4-14 b).
3. Remove the Motor Drive Assembly (See Figure
4-14 c) from the Lower Center Guide Section.
4. Remove the single (1) Encoder Circuit Board
Mounting Screw (See Figure 4-15 a) and remove
the Encoder Circuit Board (See Figure 4-15 b)
from the Drive Motor Assembly (See Figure 4-15
c).
Entrance and Exit Solenoid Removal
To remove the Transport Entrance and Exit Sol-
enoid Unit, proceed as follows:
1. Remove the CPU Circuit Board as previously
described during “CPU Circuit Board Removal”
on page 4-1 of this Section; preform the proce-
dure for “MAG Board Removal (PUB-11 Only)”
on page 4-2 of this Section, and disassemble the
Transport Drum as described in the Section titled
“Transport Drum Disassembly” on page 4-2 of
this Section. However, Steps 9, 10 and 11 of this
last procedure need not be performed if it is a
PUB-11 Unit.
2. Remove the two (2) Lower Guide Mounting
Screws from the Lower Base Assembly
(See Figure 4-16 a
1
& a
2
).
3. Remove the Lower Guide Assembly (See Figure
4-16 b).
4. Turn the Lower Base Assembly upside-down and
remove the Lower Lid by pressing in on the four
(4) Lower Lid Open/Close Release Tabs
(See Figure 4-17 a
1
through a
4
) with a Flatblade
Screwdriver, and pry the lid up and off the
Assembly (See Figure 4-17 b).
5. Next, remove the two (2) Guide Levers
(See Figure 4-18 a
1
& a
2
) from the Lower Base
Assembly (See Figure 4-18 b).
6. Remove the two (2) Solenoid mounting screws
(See Figure 4-19 a
1
& a
2
) and then remove the
Entrance and Exit Solenoids (See Figure 4-19 b &
c).
a
b
c
Figure 4-14 Motor Drive Assembly Removal
a
b
c
Figure 4-15 Encoder Circuit Board Removal
b
c
a
2
a
1
Figure 4-16 Lower Guide Assembly Removal
b
a
2
a
4
a
1
a
3
Figure 4-17 Lower Guide Assembly Cover
Removal
b
a
2
a
1
Figure 4-18 Lower Guide Lever Removals