background image

8

9

11 12 13

LP-TIMER-3

LINDGREN-PITMAN, INC.

q

  

Installation: 

  First locate your  power source. The timer beeper should be 

powered using 

only clean12-24 volt DC power. Power should always come from a breaker that does not 
exceed its maximum ratedamperage.  The timer beeper draws approximately 1 amp at full load.

1. Hook Counter

3. Seconds

Between Hooks

9. Brightness

14. Timer Start Button

15. Timer Stop

2. Buoy  Counter

4. Seconds

Between Buoys

7. Adjustment Keys

for Hook Timer

10. Adjustment

Keys for Buoy

Timer

Button

16

16

16

16

5. Hook Count Reset

6. Buoy Count Reset

Hook and Buoy Timer/Counter

Installation and Instruction Sheet

q

  

Mounting: 

  The enclosure is rated for a marine environment but care should be taken to place it 

where it is not exposed to extreme weather or direct sunlight. It comes prewired so there should be no 
need to openthe enclosure. Use the aluminum bracket attached to the back of the timer to preposition the 
hole locations. Ifnecessary the bracket can be removed using a philips screwdriver.  Once the holes are
located replace thebracket and mount the unit.

Only under extremely tight conditions should mounting without the bracket be attempted and 

extra 

special attention will be required or the unit will not operate

.

  Remove the face of the unit by removing 

the four philips screws that hold the face to the body (16). 

 Carefully 

unplug the 8-pin terminal that 

connects the membrane touch panel to the circuit board (the blue connector).  If you are not careful the 
ribbon cable will tear and the unit will not function. Do so by wiggling the connector from side to side while 
pushing it towards the display.Please note the wire that attaches the touch panel to the circuit board is 
short and can be easily damaged, do not pry or pull on it. You can also use a small screwdriver to push the 
blue connector towards the displays until it unplugs from its mount on the circuit board. With the face 
removed the base can be mounted using the holes located underneath the four philips screws that hold 
the cover on the box (16).  Use water-resistant marine grade 16 gauge tinned copper two conductor wire
 

or similar to connect the timer beeper to the power source and speaker. Once the mounting is complete 

reconnect the 8-pin terminal strip to the unit and reinstall the four cover screws.

Отзывы: